? semiconductor components industries, llc, 2006 august, 2006 ? rev. 3 1 publication order number: MAC229A8FP/d MAC229A8FP, mac229a10fp triacs silicon bidirectional thyristors designed primarily for industrial and consumer applications for full wave control of ac loads such as appliance controls, heater controls, motor controls, and other power switching applications. ? all diffused and glass ? passivated junctions for parameter uniformity and stability ? small, rugged, thermowatt construction for low thermal resistance and high heat dissipation ? center gate geometry for uniform current spreading ? gate triggering guaranteed in four modes ? indicates ul registered ? file #e69369 ? device marking: logo, device type, e.g., MAC229A8FP, date code maximum ratings (t j = 25 c unless otherwise noted) rating symbol value unit peak repetitive off ? state voltage (1) (t j = ? 40 to 110 c, sine wave 50 to 60 hz, gate open) MAC229A8FP mac229a10fp v drm, v rrm 600 800 volts on-state rms current (t c = 80 c) full cycle sine wave 50 to 60 hz i t(rms) 8.0 amps peak non ? repetitive surge current (one full cycle sine wave, 60 hz, t j = 110 c) i tsm 80 amps circuit fusing consideration (t = 8.3 ms) i 2 t 26 a 2 s peak gate current (t 2 s,t c = 80 c) i gm 2.0 amps peak gate voltage (t 2 s, t c = 80 c) v gm 10 volts peak gate power (t 2 s,t c = 80 c) p gm 20 watts average gate power (t c = 80 c, t 8.3 ms) p g(av) 0.5 watt rms isolation voltage (t a = 25 c, relative humidity 20%) () v (iso) 1500 volts operating junction temperature range t j ? 40 to 110 c storage temperature range t stg ? 40 to 150 c mounting torque ? 8.0 in. lb. (1) v drm and v rrm for all types can be applied on a continuous basis. blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. (2) the case temperature reference point for all tc measurements is a point on the center lead of the package as close as possible to the plastic body. isolated triac 8 amperes rms 600 thru 800 volts device package shipping ordering information MAC229A8FP isolated to220fp 500/box http://onsemi.com mt1 g mt2 isolated to ? 220 full pack case 221c style 3 1 2 3 pin assignment 1 2 3 main terminal 2 gate main terminal 1 () mac229a10fp isolated to220fp 500/box
MAC229A8FP, mac229a10fp http://onsemi.com 2 thermal characteristics characteristic symbol max unit thermal resistance, junction to case r jc 2.2 c/w thermal resistance, case to sink r cs 2.2 c/w thermal resistance, junction to ambient r ja 60 c/w maximum lead temperature for soldering purposes 1/8 from case for 10 seconds t l 260 c electrical characteristics (t c = 25 c unless otherwise noted; electricals apply in both directions) characteristic symbol min typ max unit off characteristics peak repetitive blocking current (1) (v d = rated v drm , v rrm ; open gate) t j = 25 c t j = 110 c i drm , i rrm ? ? ? ? 10 2.0 a ma on characteristics peak on-state voltage (i tm = 11 a peak, pulse width 2 ms, duty cycle 2%) v tm ? ? 1.8 volts gate trigger current (continuous dc) (v d = 12 v, r l = 100 ) mt2(+), g(+); mt2(+), g( ? ); mt2( ? ), g( ? ) mt2( ? ), g(+) i gt ? ? ? ? 10 20 ma gate tri gger v oltage (continuous dc) (v d = 12 v, r l = 100 ) mt2(+), g(+); mt2(+), g( ? ); mt2( ? ), g( ? ) mt2( ? ), g(+) v gt ? ? ? ? 2.0 2.5 volts gate non ? trigger v oltage (continuous dc) (v d = 12 v, t c = 110 c, r l = 100 ) all four quadrants v gd 0.2 ? ? volts holding current (v d = 12 vdc, initiating current = 200 ma, gate open) i h ? ? 15 ma gate ? controlled turn ? on time (v d = rated v drm , i tm = 16 a peak, i g = 30 ma) t gt ? 1.5 ? s dynamic characteristics critical rate of rise of off ? state voltage (v d = rated v drm , exponential waveform, t c = 110 c) dv/dt ? 25 ? v/ s critical rate of rise of commutation voltage (v d = rated v drm , i tm = 11.3 a, commutating di/dt = 4.1 a/ms, gate unenergized, t c = 80 c) dv/dt(c) ? 5.0 ? v/ s (1) ratings apply for open gate conditions. devices shall not be tested with a constant current source for blocking voltage such that the v oltage applied exceeds the rated blocking voltage.
MAC229A8FP, mac229a10fp http://onsemi.com 3 + current + voltage v tm i h symbol parameter v drm peak repetitive forward off state voltage i drm peak forward blocking current v rrm peak repetitive reverse off state voltage i rrm peak reverse blocking current voltage current characteristic of triacs (bidirectional device) i drm at v drm on state off state i rrm at v rrm quadrant 1 mainterminal 2 + quadrant 3 mainterminal 2 ? v tm i h v tm maximum on state voltage i h holding current mt1 (+) i gt gate (+) mt2 ref mt1 ( ? ) i gt gate (+) mt2 ref mt1 (+) i gt gate ( ? ) mt2 ref mt1 ( ? ) i gt gate ( ? ) mt2 ref ? mt2 negative (negative half cycle) mt2 positive (positive half cycle) + quadrant iii quadrant iv quadrant ii quadrant i quadrant definitions for a triac i gt ? + i gt all polarities are referenced to mt1. with in ? phase signals (using standard ac lines) quadrants i and iii are used.
MAC229A8FP, mac229a10fp http://onsemi.com 4 i t(rms) , rms on?state current (amp) 6.0 0 104 98 92 5.0 1.0 2.0 3.0 4.0 110 t 7.0 8.0 i t(rms) , rms on?state current (amp) p , case temperature ( c) c 6.0 0 4.0 2.0 0 5.0 1.0 2.0 3.0 4.0 7.0 8.0 , average power (watts) (av) 120 90 60 30 180 120 90 60 = 30 6.0 8.0 10 86 80 dc dc t j 110 c = conduction angle = conduction angle = 180 figure 1. rms current derating figure 2. on ? state power dissipation
MAC229A8FP, mac229a10fp http://onsemi.com 5 package dimensions isolated to ? 220 full pack case 221c ? 02 issue c notes: 1. dimensioning and tolerancing per ansi y14.5m, 1982. 2. controlling dimension: inch. 3. lead dimensions uncontrolled within dimension z. ? y ? ? b ? ? t ? q p a k h z g l f d 3 pl m b m 0.25 (0.010) y e n s j r c seating plane dim min max min max millimeters inches a 0.680 0.700 17.28 17.78 b 0.388 0.408 9.86 10.36 c 0.175 0.195 4.45 4.95 d 0.025 0.040 0.64 1.01 e 0.340 0.355 8.64 9.01 f 0.140 0.150 3.56 3.81 g 0.100 bsc 2.54 bsc h 0.110 0.155 2.80 3.93 j 0.018 0.028 0.46 0.71 k 0.500 0.550 12.70 13.97 l 0.045 0.070 1.15 1.77 n 0.049 ??? 1.25 ??? p 0.270 0.290 6.86 7.36 q 0.480 0.500 12.20 12.70 r 0.090 0.120 2.29 3.04 s 0.105 0.115 2.67 2.92 z 0.070 0.090 1.78 2.28 123 style 3: pin 1. mt 1 2. mt 2 3. gate on semiconductor and are registered trademarks of semiconductor components industries, llc (scillc). scillc reserves the right to mak e changes without further notice to any products herein. scillc makes no warranty, representation or guarantee regarding the suitability of its products for an y particular purpose, nor does scillc assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including wi thout limitation special, consequential or incidental damages. ?typical? parameters which may be provided in scillc data sheets and/or specifications can and do vary in different application s and actual performance may vary over time. all operating parameters, including ?typicals? must be validated for each customer application by customer?s technical experts. scillc does not convey any license under its patent rights nor the rights of others. scillc products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the scillc product could create a sit uation where personal injury or death may occur. should buyer purchase or use scillc products for any such unintended or unauthorized application, buyer shall indemnify and hold scillc and its of ficers, employees, subsidiaries, af filiates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, direct ly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that scillc was negligent regarding the design or manufacture of the part. scillc is an equal opportunity/affirmative action employer. this literature is subject to all applicable copyright laws and is not for resale in any manner. publication ordering information n. american technical support : 800 ? 282 ? 9855 toll free usa/canada europe, middle east and africa technical support: phone: 421 33 790 2910 japan customer focus center phone: 81 ? 3 ? 5773 ? 3850 MAC229A8FP/d literature fulfillment : literature distribution center for on semiconductor p.o. box 5163, denver, colorado 80217 usa phone : 303 ? 675 ? 2175 or 800 ? 344 ? 3860 toll free usa/canada fax : 303 ? 675 ? 2176 or 800 ? 344 ? 3867 toll free usa/canada email : orderlit@onsemi.com on semiconductor website : www.onsemi.com order literature : http://www.onsemi.com/orderlit for additional information, please contact your local sales representative
|
